Pt-CeOx/MWCNT electrocatalysts as ethanol-tolerant ORR cathodes for Direct Alcohol Fuel Cells

Pt-CeOx/MWCNT electrocatalysts as ethanol-tolerant ORR cathodes for Direct Alcohol Fuel Cells

F.J. Rodriguez VarelaA.A. Gaona Coronado J.C. Loyola Qi-Zhong Jiang  P. Bartolo Perez 

Nanosciences and Nanotechnology Program, CINVESTAV Unidad Saltillo Carr. Saltillo-Monterrey Km. 13.5, Ramos Arizpe, Coahuila, C.P. 25900, México

Instituto Tecnológico de Saltillo, V. Carranza 2400, Col. Tecnológico, C.P. 25280, Saltillo, Coahuila México

Department of Chemical Engineering, Shanghai Jiao Tong University, Shanghai, China, 200240

CINVESTAV-IPN, Unidad Mérida, Departamento de Física Aplicada, A. P. 73 Cordemex, 97310, Mérida, Yuc., Mexico

Corresponding Author Email: 
javier.varela@cinvestav.edu.mx
Page: 
75-80
|
DOI: 
https://doi.org/10.14447/jnmes.v14i2.113
Received: 
November 01, 2010
|
Accepted: 
February 01, 2011
|
Published: 
April 06, 2011
| Citation
Abstract: 

High performance 20% Pt-CeOx (1:1 Pt:Ce weight ratio) electrocatalyst dispersed on Multiwalled Carbon Nanotubes (MWCNTs) was synthesized under H2 atmosphere at 300 °C. The average particle size determined from XRD was ca. 1.7 and 10 nm for Ce and Pt, respectively. HRTEM analysis confirmed the presence of particle sizes within this range, although it was not possible to distinguish Ce from Pt nanoparticles. The XPS spectrum of Ce showed characteristics that indicate the existence of both oxidized and reduced phases (i.e., Ce2O3 and CeO2). It is suggested that the presence of the C3+ state establishes the capacity of this material to act as a tolerant cathode. The spectrum of Pt confirmed the presence of Pt metal. The 20% Pt-CeOx/MWCNT cathode showed high electroactivity for the Oxygen Reduction Reaction (ORR). Moreover, this novel material presented a high degree of tolerance to ethanol. During polarization tests in ethanol-containing solution, the Pt-CeOx/MWCNT cathode showed no peak current density due to the ethanol oxidation reaction (EOR) and the onset potential for the ORR shifted by only 80 mV towards more negative potentials. Thus, the presence of ceria clearly enhanced the electrochemical tolerance of the Pt-based cathode to ethanol.

Keywords: 

 Pt-CeOx cathodes, ORR, tolerance to ethanol, Direct Alcohol Fuel Cells 

1. Introduction
2. Experimental
3. Results and Discussion
4. Conclusions
5. Acknowledgements

The authors thank the Mexican Council for Science and Technology (CONACYT) for financial support through grant 79870 and the Innovative Networks Program. 

  References

[1] E. Antolini, T. Lopes and E.R. Gonzalez, J. Alloys Compd., 461, 253 (2008).

[2] D. Morales-Acosta, L.G. Arriaga, L. Alvarez-Contreras, S. Fraire Luna and F.J. Rodríguez Varela, Electrochem. Commun., 11, 1414 (2009).

[3] P. Hernández-Fernández, S. Rojas, P. Ocón, A. de Frutos, J.M. Figueroa, P. Terreros, M.A. Peña and J.L.G. Fierro, J. Power Sources, 177, 9 (2008).

[4] O. Savadogo, K. Lee, S. Mitsushima, N. Kamiya and K-I Ota, J. New Mat. Electrochem. Systems, 7, 77-83 (2004).

[5] S. Song, Y. Wang, P. Tsiakaras and P.K. Shen, Appl. Catal. B, 78, 381 (2008).

[6] V. Baglio, A. Stassi, A. Di Blasi, C. D’Urso, V. Antonucci and A.S. Aricò, Electrochim. Acta, 53, 1360 (2007).

[7] P. Nekooi, M. Akbari and M.K. Amini, Int. J. Hydrogen Energy, 35, 6392 (2010).

[8] L. Xiong and A. Manthiram, Electrochim. Acta, 49, 4163 (2004).

[9] H.B. Yua, J.-H. Kim, H.-I. Lee, M.A. Scibioh, J. Lee, J. Han, S.P. Yoon and H.Y. Ha, J. Power Sources,140, 59 (2005).

[10] X. Wang, W. Xu, X. Zhou, T. Lu, W. Xing, Ch. Liu and J. Liao, J. Solid State Electrochem., 13, 1449 (2009).

[11] M.A. Scibioh, S.-K. Kim, E.A. Cho, T.-H. Lim, S.-A. Hong, H.Y. Ha, Appl. Catal. B, 84, 773 (2008).

[12] L. Shen, Q.-Z. Jiang, T. Gan, M. Shen, F.J. Rodriguez Varela, A.L. Ocampo and Z.-F. Ma, J. New Mat. Electrochem. Systems, 13, 205 (2010).

[13]D.-J. Guo and Z.-H. Jing, J. Power Sources, 195, 3802 (2010).

[14] J. Wang, J. Xi, Y. Bai, Y. Shen, J. Sun, L. Chen, W. Zhu, X. Qiu, J. Power Sources, 164, 555 (2007).

[15] K.H. Lee, K. Kwon, V. Roev, D.Y. Yoo, H. Chang, D. Seung, J. Power Sources, 185, 871 (2008).

[16] R.F.B. De Souza, A.E.A. Flausino, D.C. Rascio, R.T.S. Oliveira, E. Teixeira Neto, M.L. Calegaro and M.C. Santos, Appl. Catal. B, 91, 516 (2009).

[17] J.W. Guo, T.S. Zhao, J. Prabhuram, R. Chen and C.W. Wong, J. Power Sources, 156, 345 (2006).

[18] F. Zhang, P. Wang, J. Koberstein, S. Khalid, S.-W. Chan, Surface Science, 563, 74 (2004).

[19] D. Morales-Acosta, D. López de la Fuente, L.G. Arriaga and F. J. Rodríguez Varela, Int. J. Electrochem. Sci., (2011) accepted for publication.

[20] F.J. Rodríguez Varela, S.E. González Ramírez and R. Dabek Klapco, J. New Mat. Electrochem.Systems, 12, 9 (2009).

[21] F.J. Rodríguez Varela and O. Savadogo, J. Electrochem. Soc., 155, B618 (2008).